Your Guide to wood laminate flooring on concrete for your home

Most people are unaware of the actual use of a laminate underlay. So if you are planning to buy it for your home, it may be helpful to know the basics. Underbody underlayment is essentially used to reduce the cavity sound created by newly installed laminate flooring. In other words, you may have thought that newly laid laminate floors will cause a disturbing noise when you enter the surface. If you want to get rid of this strange sound, using an underpayment is highly recommended. The typical base is made of foam and supplied in the form of rolls.

Is it possible to install it yourself?

Laying laminate flooring is a pretty simple task. You can easily do this yourself by following a series of simple but effective steps. Some tips that might be useful in this regard are described below.

Go for the right underpayment:

There are many different types of underpayments available in the market in different price ranges. You may be tempted to look at the cheaper ones, as there is no obvious difference between the good and the low ones. But you must be aware of the fact that the cheaper ones have no barrier to moisture protection. It is therefore strongly recommended that you buy a high-quality base, especially if you want to install it in a room with excessive moisture, such as water. In a kitchen.

Look at the subsoil

Underpayment should correct the imperfections found in the level of the ground to nearly 1/8 inch. This step is very critical because you do not even want to get a slightly crooked bottom. All you need is a 12 & # 39; & # 39; X4 & # 39; board. You need to place the plate at each end of the floor and use a tape measure to see if the edges on each side are the same or not.


To lay the laminate underlay, you must press the straight edge firmly against the wall surface. The edge of the tape overlaps the piece that is installed next for me. Then all you have to do is roll out the entire underlay roll until it approaches the other wall.